A. Alarm volume adjust
B. Chime volume adjust
C. Visual indicator area
D. Speaker
Whilst powered up, press both the alarm and chime volume adjust buttons simultaneously and hold for 2 seconds. The blue LED will illuminate to indicate the sounder is in configuration mode. Configuration mode will automatically timeout after 10 seconds of inactivity.
Press both the alarm and chime volume adjust buttons simultaneously whilst the sounder is in configuration mode to switch between the light enabled and disabled. The white light will extinguish/illuminate to show the current setting.
In configuration mode, press the alarm volume adjust button to cycle through volume levels 1 to 4 and mute. The red LED will illuminate whilst cycling through. The first button press plays the Alarm tone at the current setting, subsequent presses adjust the volume.
In configuration mode, press the chime volume adjust button to cycle through volume levels 1 to 4 and mute. The red LED will illuminate whilst cycling through. The first button press plays the Chime tone at the current setting, subsequent presses adjust the volume.
The sounder will automatically exit configuration mode if no buttons have been pressed on the device for 10 seconds.
The device will double beep 5 times and then will pause for 30 minutes. At the end of 30 minutes the device will enter a cycle of double beeping 5 times then pausing for 10 seconds.
The cycle will repeat until the device runs out of battery, the device is turned off or the mains power is restored.
The device will illuminate and stay illuminated until the device runs out of battery, the device is turned off or the mains power is restored.
Switch mains supply off or remove the device from the wall socket. Press and hold both volume buttons until the device LEDs all extinguish.
Rapid tones alternating high and low.
Rapid flashing white LED light.
Slow repeating tones (if chime follow is selected) or singular tone otherwise.
Slow flashing white LED light.
Slow tones alternating from low to high.
The white LED illuminates and stays on constantly.
A constant tone is on whilst the entry or exit timer is active.
The white LED illuminates and stays on constantly.
Applies to electrical products sold within the European community. At the end of the electrical product’s life, do not dispose of it with household waste. Where possible, recycle the product. Check with your Local Authority or retailer for recycling advice in your country. When disposing of the product, the battery must be removed and disposed of separately in accordance with the local regulations. Hereby Pyronix declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The declaration of conformity may be consulted at stage.pyronix.com/uk/terms-conditions-sales/p
This product is sold subject to our standard warranty conditions and is warranted against defects in workmanship for a period of two years. In the interest of continuing care and design, Pyronix Ltd reserves the right to amend specifications without giving prior notice.
